Scratch and contact
TIG torches

A range of Kemppi scratch-start TIG torches with shielding gas valves in the neck.

Kemppi’s TIG torch range includes three torches equipped with a torch neck shielding gas valve. This also makes it possible to use these TIG torches with MMA power sources.

In manual metal arc welding (MMA), the TIG arc can normally be ignited only with the scratch method, and therefore these torches are called scratch-start TIG torches. The arc is ignited by scratching the work piece with the electrode and turned off by pulling the torch away from the work piece.

NOTE! When using scratch-start ignition, the torch remains live after welding.

The TTC 220GV torch is an exception to this rule, as it allows for using scratch-start ignition. Therefore, the torch is active only when the switch is pressed.

TTM 15 V torch
In type-labelling, the letter 'V' means that there is a valve in the torch neck for the shielding gas. The torch is equipped with a 4-metre torch cable.

This torch model is suitable for use with all MMA welding power sources with a small cable connector. These include the Kemppi Minarc 120. 150, and 151.

TTM 15 V BC torch
In type-labelling, the letter 'V' means that there is a valve in the torch neck for the shielding gas. The torch is equipped with a 4-metre torch cable.

This torch model is suitable for use with all MMA welding power sources with a big cable connector (BC = big connector). These include the Kemppi Master 2500, 3500, Master 2850, and Minarc 220.

TTC 220 GV torch
In type-labelling, the letters 'GV' mean that there is a valve in the torch neck for the shielding gas. The torch is equipped with a 4-metre torch cable.

This torch model is equipped with a big connector and is compatible with the following Kemppi welding machines: Master 2500 MLS™, Master 3500 MLS™ and Minarc 220.

Benefits of the TTC 220GV torch

• Operational safety, as the arc will ignite and burn only when the switch is pressed down.
• Ease of use, as the welding current can be adjusted from the torch handle using the RTC 10 remote control unit included in the basic set-up.
• Versatility, as the torch remote controller can also be used for MMA welding.